[Top] [Prev] [Next] [Bottom]

Notices and Standards Statements

Notices

The information in this document is subject to change without notice.

OpenROUTE Networks, Inc. assumes no responsibility for any damages arising from the use or inability to use this document, including but not limited to lost revenue, lost data, claims by third parties, or other damages.

For complete warranty information, please see the product's warranty, which covers both this document and its product.

Copyright Notice

Copyright© OpenROUTE Networks, Inc. 1998. All rights reserved.

No part of this document may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable form without the prior written consent of OpenROUTE Networks, Inc.

Software Copyright Notice

Copyright© OpenROUTE Networks, Inc. 1998.

Trademark Notice

OpenROUTE is a registered trademark and GTSecure is a trademark of OpenROUTE Networks, Inc. All other products or brand names are trademarks or registered trademarks of their respective holders, as marked.

Federal Communications Commission (FCC) Statement

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

This equipment is designed for use with properly terminated cables. Refer to the installation section of this manual before operation.

Reference: CFR 47, Part 15, Subparts A & B, June 23, 1989

FCC Part 68 Compliance Statement

This equipment complies with the Part 68 of the FCC Rules. The label included on the bottom of the GTX Series router contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. If requested, provide this information to your telephone company.

This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant.

The REN is useful to determine the quantity of devices you may connect to your telephone line and still have those devices ring when your number is called. In most, but not all areas, the sum of the RENs of all devices should not exceed five (5.0). To be certain of the number of devices you may connect to your line, as determined by the REN, you should call your local telephone company to determine the maximum REN for your calling area.

If the terminal equipment causes harm to the telephone network, the telephone company, may discontinue your service temporarily. If possible, they will notify you in advance. But if advance notice is not practical, you will be notified as soon as possible. You will be advised of your right to file a complaint with the FCC.

Your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the proper operation of your equipment. If they do, you will be given advance notice so as to give you an opportunity to maintain uninterrupted service.

No repairs can be performed by the customer.

Canadian Standards Association (CSA) Statement

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled: Digital Apparatus. CES-003 of Industry Canada.

Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numérique de Classe B prescrites dans la norme sur le matériel brouiller: Appareil numérique, NMB-003 édictée par Industrie Canada.

Industry Canada CS-03 Compliance Statement

The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The department does not guarantee the equipment will operate to the user's satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.

U.K. Safety Approval

The GTX Series router is manufactured to the International Safety Standard EN 60950 and as such is approved in the U.K. under General Approval number NS/G/1234/J/10003 for indirect connection to the public telecommunication network.

European Community (EC) Mark of Conformity Statement

This product is in conformity with the protection requirements of EC Council Directives 73/23/EEC (Low Voltage Directive) and 89/336/EEC amended by 92/31/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. OpenROUTE Networks, Inc. cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product, including the fitting of non-OpenROUTE Networks, Inc. option cards.

Properly shielded and grounded cables and connectors must be used in order to reduce the potential for causing interference to radio and TV communications and to other electrical or electronic equipment.

This product bears the Telecom CE Mark (CE 168 X) for WAN complying with i-CTR2, i-CTR3, CTR12, and CTR13 (Bridging measures) per the European Directive 91/263/EEC
(TTE Directive).

A signed copy of the Declaration of Conformity is on file and available from OpenROUTE Networks per directive 91/263/EEC.

This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to CISPR 22/European Standard EN 55022. The limits for Class B equipment were derived for typical residential environments to provide reasonable protection against interference with licensed communication devices.

Dieses Gerät erfüllt die Bedingungen der EN 55022 Klasse B.

OpenROUTE Networks Customer Service
Hours 24 hours, 7 days/week
Telephone North America (508) 870-2255 Europe (44) 990 506 500 Pacific Rim (65) 732-2727
FAX North America (508) 366-9146 Europe (44) 1509-670602 Pacific Rim (65) 733-8522
FAX for RMAs and Contract Administration (508) 898-2118
FTP Server ftp.openroute.com (128.185.123.16)
E-mail Address prohelp-cs@openroute.com
Educational Services
Telephone North America (508) 898-2169
To Order Products and/or Literature
Telephone (508) 898-2150
FAX (508) 366-7930
Product Information
Telephone and
FaxBack 		North America (800) 545-RING (7464)
Europe (508) 836-5321 Pacific Rim (508) 836-5321
World Wide Web Page
For product information, white papers, and technical information: http://www.openroute.com

Safety Information

CAUTION:

For your personal safety, follow these guidelines before installing the GTX Series router.


[Top] [Prev] [Next] [Bottom]

docs@openroute.com
Copyright © 1998, OpenROUTE Networks, Inc. All rights reserved.