[Top] [Prev] [Next] [Bottom]
CNX 600 User Guide
Chapter 1 Introduction
- General Description
- Booting Methods
- Equipment and Configuration Requirements
- Front Panel
- Back Panel
- LCD Status Window and Buttons
- Power Supply
- Internal Modem
Chapter 2 Installing the CNX 600
Chapter 3 Quick Configuration
Chapter 4 Power-up Diagnostics
- General Description
- Router Power-up Diagnostic Program
- FDDI Power-up Diagnostic Program
Chapter 5 Ethernet (Dual) Interface Card
- General Description
- RJ-45 Connector LED
- Front Bracket LEDs
- Cable Specifications
Chapter 6 Ethernet (Quad) Interface Card
- General Description
- Burned-in Address (BIA) Locations
- Front Bracket LEDs
- Cable Specifications
Chapter 7 FDDI Interface Card
- General Description
- Line States
- Front Bracket LEDs
- Model p3914 FDDI Patch Cables
- Model p4291 FDDI Optical Bypass Switch
Chapter 8 Serial (Quad) Interface Card -
Model # 4524
- General Description
- Front Bracket LEDs
- Rear Bracket LEDs
- Level Converters
Chapter 9 Serial (Twin) Interface Card -
Model # 4523
- General Description
- Front Bracket LEDs
- Rear Bracket LEDs
- Level Converters
Chapter 10 Token-Ring (Dual) Interface Card
- General Description
- Front Bracket LEDs
- Cable Specifications
Chapter 11 Boot/Dump PROM
Error Messages
- General Boot/Dump PROM Error Messages
- Ethernet Boot/Dump PROM Error Messages
- FDDI Boot/Dump PROM Error Messages
- Serial (Twin and Quad) Boot/Dump PROM Error Messages
- Token-Ring Boot/Dump PROM Error Messages
Chapter 12 Maintenance
- Opening the Chassis
- Removing a Network Interface Card
- Installing a Network Interface Card
- Installing a Level Converter on the Serial Cards
- Closing the Chassis
- Voltage Fuse Replacement
Appendix A Specifications
Appendix B DDT Commands
Appendix C Accessing the Boot Options
from the LCD
[Top] [Prev] [Next] [Bottom]
docs@openroute.com
Copyright © 1997, OpenROUTE Networks, Inc. All rights
reserved.