[Top] [Prev] [Next] [Bottom]
Notices and Standards Statements
Notice
The information in this document is subject to change without notice.
OpenROUTE Networks, Inc. assumes no responsibility for any damages arising from the use or inability to use this document, including but not limited to lost revenue, lost data, claims by third parties, or other damages.
For complete warranty information, please see the product's warranty, which covers both this document and its product.
Copyright Notice
Copyright© OpenROUTE Networks, Inc. 1997. All rights reserved.
No part of this document may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable form without the prior written consent of OpenROUTE Networks, Inc.
Software Copyright Notice
Copyright© OpenROUTE Networks, Inc. 1997.
Trademark Notice
OpenROUTE is a registered trademark and GTSecure is a trademark of OpenROUTE Networks, Inc. All other products or brand names are trademarks or registered trademarks of their respective holders, as marked.
Federal Communications Commission (FCC) Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
This equipment is designed for use with properly terminated cables. Refer to the installation section of this manual before operation.
Reference: CFR 47, Part 15, Subparts A & B, June 23, 1989
Canadian Standards Association (CSA) Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled: Digital Apparatus. CES-003 of Industry Canada.
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numérique de Classe B prescrites dans la norme sur le matériel brouiller: Appareil numérique, NMB-003 édictée par Industrie Canada.
U.K. Safety Approval
The GT 100 Series is manufactured to the International Safety Standard EN 60950 and as such is approved in the U.K. under General Approval number NS/G/1234/J/10003 for indirect connection to the public telecommunication network.
European Community (EC) Mark of Conformity Statement
This product is in conformity with the protection requirements of EC Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. OpenROUTE Networks cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product, including the fitting of non-OpenROUTE Networks option cards.
Properly shielded and grounded cables and connectors must be used in order to reduce the potential for causing interference to radio and TV communications and to other electrical or electronic equipment.
This product bears the Telecom CE Mark (CE 168 X) for WAN complying with i-CTR1 and i-CTR2 (Bridging measures) per the European Directive 91/263/EEC
(TTE Directive).
This product also complies with the Low Voltage Directive 73/23/EEC.
A signed copy of the Declaration of Conformity is on file and available from Proteon International, Lockington, England per directive 91/263/EEC.
This product has been tested and found to comply with the limits for Class B Information Technology Equipment according to CISPR 22/European Standard EN 55022. The limits for Class B equipment were derived for typical residential environments to provide reasonable protection against interference with licensed communication devices.
Dieses Gerät erfüllt die Bedingungen der EN 55022 Klasse B.
Japanese Voluntary Control Council for Interference (VCCI) Statement
This equipment is Class 2 ITE Equipment which is in conformance with the standard set by the Voluntary Control for Interference Council by Data Processing Equipment and Electronic Office Machines (VCCI) with an aim to prevent radio interference in commercial and industrial districts.
This equipment could cause interference to radio and television receivers when used in and around residential districts. Please handle the equipment properly according to the instruction manual.
Safety Information
CAUTION:
For your personal safety, follow these guidelines before installing the GTS 100.
[Top] [Prev] [Next] [Bottom]
docs@openroute.com
Copyright © 1998, OpenROUTE Networks, Inc. All rights
reserved.