[Top] [Prev] [Next] [Bottom]
Table of Contents
CNX 500 User Guide
Chapter 1 Introduction
- General Description
- Booting Methods
- Integrated Boot Device (IBD)
- TFTP Host Server
- BOOTP
- Equipment and Configuration Requirements
- Front Panel
- Back Panel
- I/O Slot Numbers
Chapter 2 Installing the CNX 500
Chapter 3 Quick Configuration
Chapter 4 Power-up Diagnostics
- General Description
- Router Power-up Diagnostic Program
- LEDs
- Console Messages
- Error Recovery
- FDDI Power-up Diagnostic Program
- LEDs
- Dual Serial Power-up Diagnostic Program
- LEDs
- Console Messages
- Error Recovery
Chapter 5 Ethernet (Dual) Interface Card
- General Description
- Burned-in Address Locations
- Port Fuses
- RJ-45 Connector LED
- Front Bracket LEDs
- Cable Specifications
Chapter 6 Ethernet (Single) Interface Card
- General Description
- Front Bracket LEDs
- Cable Specifications
Chapter 7 FDDI Interface Card
- General Description
- Line States
- Front Bracket LEDs
- Model p3914 FDDI Patch Cables
- Model p4291 FDDI Optical Bypass Switch
- Switch Description
- How the Bypass Switch Works
Chapter 8 Serial (Dual) Interface Card - Model # 4520
- General Description
- Serial Ports
- LEDs
- Level Converters
- 0 Ohm Resistor
- RS-232
- RS-449
- X.21
- V.35
Chapter 9 Serial (Twin) Interface Card - Model # 4523
- General Description
- X.25 Protocol Restriction
- DTE and DCE Cabling
- Front Bracket LEDs
- Rear Bracket LEDs
- Level Converters
- Configurable Jumpers
- 0 Ohm Resistor
- RS-232/V.35
- RS-449/X.21
- G.703
Chapter 10 Serial (Quad) Interface Card - Model # 4524
- General Description
- X.25 Protocol Restriction
- DTE and DCE Cabling
- Front Bracket LEDs
- Rear Bracket LEDs
- Level Converters
- Configurable Jumpers
- 0 Ohm Resistor
- RS-232/V.35
- RS-449/X.21
- G.703
Chapter 11 Token-Ring (Dual) Interface Card
- General Description
- Front Bracket LEDs
- Cable Specifications
- STP Cable
Chapter 12 Token-Ring (Single) Interface Card
- General Description
- Circuit Breaker
- Front Bracket LEDs
- Cable Specifications
- STP Cable
- UTP Cable
Chapter 13 Boot/Dump PROM Error Messages
- General Boot/Dump PROM Error Messages
- Ethernet Boot/Dump PROM Error Messages
- FDDI Boot/Dump PROM Error Messages
- Serial (Dual) Boot/Dump PROM Error Messages
- Serial (Twin and Quad) Boot/Dump PROM Error Messages
- Token-Ring Boot/Dump PROM Error Messages
Chapter 14 Maintenance
- Opening the Chassis
- Removing a Network Interface Card
- Installing a Network Interface Card
- Installing a Level Converter on the Dual Serial Card
- Installing a Level Converter on the Twin and Quad Serial Cards
- Closing the Chassis
- Voltage Fuse Replacement
Appendix A Specifications
- Safety Certifications
- Dimensions
- Clearances
- Environmental Requirements
- Power Requirements
Appendix B DDT Commands
Appendix C Making a Load File from
Multiple Disks
- Assembling a LOAD Under DOS
- Assembling the Load Under UNIX
- Disassembling the Load Under DOS
- Disassembling the Load Under UNIX
[Top] [Prev] [Next] [Bottom]
docs@openroute.com
Copyright © 1997, OpenROUTE Networks, Inc. All rights
reserved.