[Top] [Prev] [Next] [Bottom]
GlobeTrotter 70 and 72
Software Guide
Chapter 1 Introduction
- GlobeTrotter 70 and 72
- The Dial Circuit Protocol Stack
- WAN Manager
- PPP
- ISDN
- Devices and Interfaces
Chapter 2 Learning the User Interface and
OPCON Commands
- Using Local and Remote Router Terminals
- Using the User Interface
- Overview of the User Interface
- OPCON Commands
Chapter 3 Configuring Booting
and Dumping
- What is Boot CONFIG?
- How BOOTP Forwarding Works
- Using the Trivial File Transfer Protocol (TFTP)
- Validating a Configuration Load
- Configuring Dumping
- Boot CONFIG Commands
Chapter 4 Configuring the System
- What is CONFIG?
- Using Quick Config
- Using Config-only
- Configuring User Access
- Using CONFIG
- CONFIG Commands
Chapter 5 Monitoring the System
- What is GWCON?
- Entering and Exiting GWCON
- GWCON Commands
Chapter 6 Configuring Ethernet Interfaces
- Displaying the Ethernet Configuration Prompt
- Ethernet Configuration Commands
Chapter 7 Monitoring Ethernet Interfaces
- Displaying the Ethernet Monitoring Prompt
- Ethernet Monitoring Commands
- Ethernet Interfaces and the GWCON Interface Command
Chapter 8 Using WAN Manager
- Introducing the WAN Manager Interface
- Displaying the WAN Manager
Configuration Prompt
- WAN Manager Configuration Commands
- Displaying the WAN Manager
Monitoring Prompt
- WAN Manager Monitoring Commands
Chapter 9 The PPP Interface
- PPP Overview
- The PPP Link Control Protocol
- The PPP Network Control Protocols
- Multilink PPP
- PAP and CHAP
- Data Compression
- Data Compression on the Router
Chapter 10 Configuring PPP Interfaces
- Displaying the PPP Configuration Prompt
- Configuring PPP
- Enabling and Disabling PAP and CHAP
- Configuring PAP
- Configuring CHAP
- Configuring Data Compression
- PPP Configuration Commands
Chapter 11 Monitoring PPP Interfaces
- Displaying the PPP Monitoring Prompt
- Monitoring Data Compression
- PPP Monitoring Commands
- PPP Interfaces and the GWCON Interface Command
Chapter 12 The ISDN Interface
- ISDN Overview
- ISDN Hardware
Chapter 13 Configuring ISDN Interfaces
- Before You Begin
- Displaying the ISDN Configuration Prompt
- Configuration Procedures
- Configuring Point-to-Point ISDN
- Configuring Multipoint ISDN
- ISDN Configuration Commands
Chapter 14 Monitoring ISDN Interfaces
- Displaying the ISDN Monitoring Prompt
- ISDN Monitoring Commands
Chapter 15 Using the Event Logging System
- What is ELS?
- Entering and Exiting the ELS Configuration Prompt
- Entering and Exiting the ELS Monitoring Prompt
- Entering and Exiting MONITR
- Displaying ELS Through MONITR
- Interpreting ELS Messages
- Using ELS
- Using ELS to Troubleshoot a Problem
- ELS Configuration Commands
- ELS Monitoring Commands
[Top] [Prev] [Next] [Bottom]
docs@openroute.com
Copyright © 1997, OpenROUTE Networks, Inc. All rights
reserved.