[Top] [Prev] [Next] [Bottom]

Using the Analog Voice Commands

This document describes the command line interface commands for the analog voice module. It has the following sections.

Displaying the Voice Prompt

Voice Commands

Displaying the Voice Prompt

To display the Voice Config> prompt, enter voice at the Config> prompt.

Config>voice 

VOICE Config>

Voice Commands

Table 1 describes the Voice commands.

Press Space twice after you type a command to display the available parameters for each command. Enter help for information about using the command line interface.

[C] means the command is available at the VOICE Config> prompt.

Table 1 Voice Commands

Command Function

Config [C] Do not use this command. It is for Nx Networks technical support engineers to use in special circumstances.

Exit [C] Returns you to the previous prompt.

List [C] Displays the settings of the voice parameters that you set at the Voice Config> prompt.

Reset [C] Resets the analog voice module.

Set Address [C] Sets the IP address of the analog voice module.

Table 1 Voice Commands
Command	Function
Config [C]	Do not use this command. It is for Nx Networks technical support engineers to use in special circumstances.
Exit [C]	Returns you to the previous prompt.
List [C]	Displays the settings of the voice parameters that you set at the `Voice Config>` prompt.
Reset [C]	Resets the analog voice module.
Set Address [C]	Sets the IP address of the analog voice module.

Config [C]

Do not use this command. It is for Nx Networks technical support engineers to use in special circumstances.

Exit [C]

Returns to the previous prompt.

Syntax: exit

Example: exit

List [C]

Displays the IP address of the analog voice module.

Syntax: list

Example: list

VoIP board configuration:  IP address = 10.3.7.76

Reset [C]

Resets the analog voice module. This command causes a hardware reset and a reboot of the module software. This process takes about 45 seconds.

Syntax: reset

Example: reset

Set Address [C]

Sets the IP address of the analog voice module. You must use an address that is unique on all attached networks.

Syntax: set address =

ipaddress

Example: set address =10.3.7.76

[Top] [Prev] [Next] [Bottom]