|
QuickWeb
is a software tool that lets you configure your router using a Web
browser. QuickWeb software resides on your router.
To
run QuickWeb . . .
-
Launch
your World Wide Web browser. We recommends that you use Internet
Explorer 4.0 or later. (If you are using Netscape Navigator,
you must use version 4.0 or later.)
-
Enter
the following in the Address (or Location) text box on your
browser. Quick Web is case sensitive.
http://192.168.1.1/QuickWeb
192.168.1.1
is the default IP address of your router’s Ethernet interface.
If you change the IP address of the Ethernet interface, you will
need to use that new address to run QuickWeb in the future.
-
Follow
the onscreen instructions to begin using QuickWeb.
QuickWeb
supported in 5.2 and above. . .
In
software release 5.2 and above, QuickWeb is supported on all hardware
platforms, and it also provides support for configuring IPSec.
Note:
QuickWeb support for IPSec is not available on GT60 and GT70
hardware platforms. On those platforms, you need to use the command
line interface to set up IPSec.
|
