QuickWeb is a software tool that lets you configure your router using a Web browser. QuickWeb software resides on your router.

To run QuickWeb . . .

1. Launch your World Wide Web browser.

Nx Networks recommends that you use Internet Explorer 4.0 or later. (If you are using Netscape Navigator, you must use version 4.0 or later.)

 

2. Enter the following in the Address (or Location) text box on your browser. QuickWeb is case sensitive.

http://192.168.1.1/QuickWeb

192.168.1.1 is the default IP address of your router’s Ethernet interface. If you change the IP address of the Ethernet interface, you will need to use that new address to run QuickWeb in the future.

 

3. Follow the onscreen instructions to begin using QuickWeb.

New QuickWeb features supported in 5.2 . . .

Beginning in software release 5.2, QuickWeb is supported on all hardware platforms, and it also provides support for configuring IPSec.

 

Note:  QuickWeb support for IPSec is not available on GT60 and GT70 hardware platforms. On those platforms, you need to use the command line interface to set up IPSec.